Microphone Test
Press the button, say something and watch the bar. If it moves, your microphone works. Then record five seconds and play them back to hear how you sound.
The bar does not move. What now?
- Speak louder and closer. A very quiet mic can move the bar only a little.
- Open the Microphone list above and try each device. A laptop often has a built-in mic and a headset mic.
- Check that the mic is not muted: look for a mute switch on the headset or a mute key on the keyboard.
- On Windows open Settings, Privacy, Microphone. On Mac open System Settings, Privacy and Security, Microphone. Allow your browser.
- Close other apps that use the microphone (calls, recorders) and test again.
- Unplug and plug in a USB or Bluetooth microphone, then reload this page.
Runs in your browser. Nothing you type or open here is uploaded.
How to test your microphone
- 1
Press Test my microphone
Your browser asks to use the microphone. Choose Allow. Pick another microphone from the list if you have more than one.
- 2
Say something
Speak in your normal voice. The bar and the wave should move. The peak marker holds the loudest moment for a moment.
- 3
Record and listen
Press Record 5 seconds and play back. Speak for five seconds, then listen. If you sound clear, the microphone is ready.
What this microphone test shows
When you start the test, the page opens your microphone and draws what it hears. The bar shows how loud you are right now. A thin marker holds the highest level of the last moments, so you can see your peaks. The wave below it shows the shape of the sound. Next to these you see the name of the microphone, its sample rate and the number of channels the browser gives you.
How to read the level
The level is shown in decibels, where 0 is the loudest value a digital signal can hold. Normal speech should reach about the middle of the bar, with peaks well below the end. If the bar sits at the far right and the number stays near 0, you are too loud or too close, and the sound will distort. If the bar barely moves while you speak, the mic is quiet, far away or the wrong device is selected.
The five-second playback check
A moving bar proves the microphone sends sound. It does not tell you how you sound. Press the record button, speak for five seconds and listen to the result. Listen for hiss, hum, echo and clipping. If you hear an echo, use headphones. If the voice is very quiet, move closer or raise the input volume in your system settings.
If you see an error
- NotAllowedError means permission was refused. Click the lock icon next to the address, allow the microphone, then reload.
- NotFoundError means the browser found no microphone. Plug one in, or check that it is enabled in your system sound settings.
- NotReadableError means the microphone exists but cannot be opened. Another app is probably using it. Close calls and recorders, then try again.
The page shows the matching steps when one of these errors happens.
Using the test before a call or a recording
Run the test a few minutes before a meeting, a stream or a voice-over. Check the right device is chosen, because your system may switch to a headset when you plug it in. Say a full sentence at the volume you plan to use. Then listen to the playback. Fixing a problem now is easier than fixing it while people are waiting.
Next steps
If the test passes and you want to keep a recording, use the voice recorder. To check your camera too, try the webcam test.
Now make the video itself.
UsTube Studio turns one sentence into a finished video: script, scenes, voice-over, music and captions, ready for Shorts, Reels and TikTok.